Video Asylum

• Re: going nuts choosing ht receiver.... - SoundMike 17:37:24 05/15/05 (0)
  In Reply to: going nuts choosing ht receiver.... posted by dude on April 6, 2005 at 20:35:57:

  Look for a Denon Model. They have very good sound processing and are fairly good at two channel performance ( in Direct mode )
  
  

  ---
• panasonic sa-xr50.... - dude 14:46:06 04/08/05 (4)
  In Reply to: going nuts choosing ht receiver.... posted by dude on April 6, 2005 at 20:35:57:

  just picked up...sounds pretty good after 10hrs burn-in. at store demo, seemed to sound much better than pioneer vsx-814. the pioneer had more authority and but sounded muddy all over. the panny was clean top to bottom. tilted a little towards the top end, but hoping to settle down as others have experienced. so far, sound quality is better than expected, enjoyable, if a little "electronic" sounding.
  
  

  ---

  • SA-XR55 is out - Jon L 15:17:20 04/08/05 (3)
    In Reply to: panasonic sa-xr50.... posted by dude on April 8, 2005 at 14:46:06:

    and can be pre-ordered in Yahoo store...
    

    • SA-XR55   (Open in New Window)

    
    

    ---

    • Re: SA-XR55 is out - dude 14:13:43 04/09/05 (2)
      In Reply to: SA-XR55 is out posted by Jon L on April 8, 2005 at 15:17:20:

      could not wait...seemed like a good deal...bought 2, one for parents, one for myself. the parents sounds very good, paired with mission v60's and cheap kenwood speakers and sub for surround. mine is paired with energy veritas, nordost wires and is sounding too much on top end. awaiting break-in...
      
      

      ---

      • Re: SA-XR55 is out - azjazz 15:02:24 04/19/05 (1)
        In Reply to: Re: SA-XR55 is out posted by dude on April 9, 2005 at 14:13:43:

        Hey, dude -

        Does the SA-XR55 have individual line-in inputs for all the channels? I need 14 indivual channels of amplification (min of 60 W per channel), and want to buy 2 SA-XR55 receivers for this task. Will it meet my needs?

        I also would like the 7 channels (I won't use the '.1' subwoofer output) of each amplifier to be full bandwidth (20Hz-20kHz) output. Does the SA-XR55 allow this?

        Thanks!

        azjazz
        
        

        ---

        • Re: SA-XR55 is out - dude 20:17:11 04/22/05 (0)
          In Reply to: Re: SA-XR55 is out posted by azjazz on April 19, 2005 at 15:02:24:

          i have sa-xr50, not 55. mine has 5.1 line-in. why would you need 14 channels? it is too bad the unit does not have line-outs. would be more useful to me if can use f/r line-out to my 2 channel integrated to power front mains. this unit would then serve as a 4ch amplifier and 6.1 processor.
          
          

          ---

This post is made possible by the generous support of people like you and our sponsors:

Signature Sound

[ Signature Sound Lounge ]

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---